Feature:

– All cars are versatile and do not hurt the paint.

– The product is small and easy to carry.

– Easy installation.

– Imported rubber vacuum adsorption, strong adsorption and more durable.

Specification:

Capacity: 1/2 bicycle

Material: Aluminum alloy

Sucker: Front 4 rear 2

Sucker size: 15cm

Suitable for: 99% automobiles

Installation guide:

– First, clean the roof and suction cup with water and a towel, and apply a little water to the suction cup before installation to ensure a better sealing effect.

– Next, place the roof rack in the selected position.

– Third, press the suction cup vertically on the top of the roof with one hand while pushing the pump rod with the other hand to extract the air until the white mark enters the pump. Make sure there are no obvious signs of rebound.

– Finally, you must remove the front wheel of the bicycle, then lock the front wheel to the roof bracket, place the rear wheel on the suction cup and tighten the magic belt.

How to remove the suction cup

– After disassembling the bicycle, trim the edges of the suction cup one by one to allow air to enter and the suction cup to be removed.

Note:

1. The installation location should be flat. Do not install the bracket in an ad or seam, such as the seam between the sun and the roof.

 2. Check the roof rack every four hours, pay attention to the following: Make sure there are no signs of looseness, and make sure there are no signs of air leaks on the suction cup.

3. The speed on the expressway must not exceed 120km/h and cannot exceed the speed limit on normal roads. Do not use shrill flips during cycling or slow down when there is a curve. Also remember to drive slowly on bumpy roads.

Packing included:

1 x Suction cup roof bike rack

1 x User manual